Led Strip Lights are common in life lighting, and can be seen everywhere in various shopping malls, restaurants, and hotels outdoors. Indoors, it can be said that almost all household lighting will use led light strips. On the one hand, it is an indirect lighting method, on the other hand. It is to play a very good decorative effect and create an atmosphere of the environment. However, we can find that the Led Strip Lights sometimes emit unevenly and dimly. What is the situation? How to solve it? The quality of the solder of the Led Strip Lights is not good, and the solder joint of the LED light strip is prone to brittle cracking and falling off during the bending process. When installing the LED light strip, the bending angle is too large, resulting in the separation of the solder joint of the LED light strip from the copper foil, resulting in no light. When the led project light strip is installed, the product is excessively squeezed, which causes the led project light strip chip to be damaged or the solder joints to be deformed and fall off without lighting. The solder mask layer of the LED engineering light strip circuit board is too thick, and the solder and the circuit board cannot be completely fused together during welding, which is also a phenomenon of virtual welding. For the SMD LED Strip Lights, it must be equipped with a controller to be effective, and the length of the light strip that can be controlled by a controller varies from 5 meters to 20 meters, depending on which specification of the controller is selected. In this way, after purchasing the led strip, it is necessary to purchase additional controllers according to the control length of the controllers, or additionally purchase RGB amplifiers (each amplifier can be extended by 5 meters). Don't mistakenly think that one controller can realize the control requirements of all led project light strips, this is a wrong point of view. For example, a 100-meter led light strip is purchased, and the controller is a conventional controller, that is, the control range of each controller is 5 meters. Then a 100-meter led project light strip needs to be equipped with 20 RGB controllers, or buy one RGB controller and another 19 amplifiers. Regular LED strips will be packaged in anti-static reels, usually 5 meters or 10 meters, and then sealed with anti-static and moisture-proof packaging bags. The copycat version of the led light strip will use a recycled reel for cost savings, and then there is no anti-static and moisture-proof packaging bag. If you look closely at the reel, you can see the traces and scratches left when the label is removed on the surface.
